Manual Controller

Model: FC-1VAC

Manual Controller

Model: FC-1VAC
An inexpensive control for variable speed fans or heat lamps

The Manual Speed Control is a simple and effective way to control fan motors. The FC-1VAC allows you to manually adjust the speed of ventilation or heating equipment.

The FC-1VAC can also be used as a light dimmer for brooder heat lamps and can power up to five 250-watt lamps.

The FC-1VAC is ideal for poultry, livestock, greenhouse, or light industrial buildings.

NOTE: An 8.5 A version, model FC-1VAC-8.5, is also available

$123.00

Downloads
SKU: FC-1VAC Category:

FC-1VAC | Manual Controller

  • One variable output
  • ON/OFF switch
  • Adjustable HIGH/LOW settings
  • Overload protection fuse
  • NEMA 4X enclosure (Corrosion-resistant, water-resistant, and fire-retardant)
  • CSA approval
  • CE certification
  • Limited warranty
  • Incoming power
    120/230 VAC, 50/60 Hz
  • Variable stage fuse
    15 A, 250 VAC ABC-type ceramic
  • Variable stage
    12.5 A at 120/230 VAC, general-purpose (resistive)
    9 FLA at 120/230 VAC, PSC motor
    1/2 HP at 120 VAC, 1 HP at 230 VAC, PSC motor
    1500 W tungsten at 120 VAC

NOTE: An 8.5 A version, model FC-1VAC-8.5, is also available

Ten pack of 15 A fuses

View Product

General

Does this replace the MSC-4/MSC-4-8.5?

Yes, it is a direct replacement for the MSC-4/MSC-4-8.5.

What is the variable stage rating?

12.5 A at 120/230 VAC, general-purpose (resistive)
9 FLA at 120/230 VAC, PSC motor
1/2 HP at 120 VAC, 1 HP at 230 VAC, PSC motor
1500 W tungsten at 120 VAC

Does this control use a temperature sensor?

No. The control is manual and adjusts output using the knob on the front.

How many fans can it control?

The limiting factor is the variable stage rating. Add up the current draw of the fans you want to control and compare it to the variable stage rating. If the combined fans draw less than the variable stage rating, then you can control them.

Can it control lights?

Yes. This control can be used as a light dimmer for brooder heat lamps and control up to five 250-watt lamps.

How big is the control?

The enclosure is 4.75 x 7.80 x 3.75 in. (12 x 15.6 x 9.5 cm). The switch and knob add an additional 0.75 in. (1.9 cm) to the depth.

Installation

Does it matter which wire I attach to the power and which I attach to the fan?

Wire the control as shown in the user manual.

Troubleshooting

Why does the fan growl when I turn the knob all the way down?

If you want the fan to idle you need to increase the Low Limit trimmer. If you want the fan to be off you need to decrease the Low Limit trimmer. For more information, see Limits for 120/230 VAC fans in the user manual.

Why does my fan not run at full speed when I turn the knob all the way up?

You may need to increase the High Limit trimmer. For more information, see Limits for 120/230 VAC fans in the user manual.

Related Products